Focus On Oracle

Installing, Backup & Recovery, Performance Tuning,
Troubleshooting, Upgrading, Patching

Oracle Engineered System


当前位置: 首页 » 技术文章 » 案列分析

Oracle ILOM Issue

Oracle的ILOM使用很方便。ILOM模块一般会集成在主板上,如果ILOM坏了,就需要把整个板子换掉,下面的输出就是由于ILOM在Preboot阶段的输出。

Preboot> help

Commands and keywords are case-sensitive and do not abbreviate.
Type "help cmd" [Enter] for summary of 'cmd' command.

boot Boot ILOM (bootcmd="bootpkg").
vers {[ brief ]| all }
Show versions.
show {[ brief ]| all | date | env }
Show settings.
edit Change settings, other than SP network.
diag { quick | normal | extended | help | test_* ... | util_* ... }
Run pre-boot diagnostics or any "test_*" or "util_*" command.
host { clearcmos | show | enable-on | hard-off }
Clear CMOS settings, enable/kill power.
net { config | dhcp | ping }
Type "help net FUNC" for help on that function.
net config Change SP network settings (static? <Missing> on SP/NET0).
net dhcp Request or renew a DHCP lease for "net" commands.
net ping <192.168.33.44>
Ping the IPv4 host (numeric).
reset {[ warm ]| cold }
reset [warm] Warm-reset the SP.
unconfig { ilom_conf | all }
unconfig ilom_conf
Set 'preserve_conf' to 'no' for next ILOM boot, but keep SP
network and baudrate, preferred, check_physical_presence.
help [cmd]
h[elp] Print list of commands.

Preboot> vers
Date ='Fri Sep 16 16:11:06 PDT 2016', Build ='r112301'
Bad root CRC=ae747100 for data =[ *00340000, len=f97000, sum=6a1ae468 ] in pkg *00140000
Bad vbscdir CRC=860e7944 for data =[ *01770000, len=4d000, sum=94a4d77c ] in pkg *00140000
uboot @0c0000 OK, kernel @142000 OK, root @340000 Bad,
vbscdir @1770000 Bad
First (preferred) ILOM image at 0x000c0000:
Not found
Second ILOM image at 0x018c0000:
Not found
Preboot> show
Date: 2017-03-23 (Thursday) Time: 6:44:44

Connectivity settings:
Console serial speed : baudrate = '9600'
Serial port multiplexer : serial_is_host = '<not set>'
Out-of-band mgmt port : ethaddr = '00:10:E1:BB:AF:FC'
Sideband mgmt ports : eth1addr = '00:10:E1:BB:AF:FC'
Network port (for ILOM) : managementport = '<not set>'
Net configuration mode : ipdiscovery = '<not set>'
Net address (for U-Boot) : ipaddr = '<not set>'
Net default gateway : gatewayip = '<not set>'
Net mask (for U-Boot) : netmask = '<not set>'

Other customer settings, with initial default in [brackets]:
(The factory default after booting might differ.)
baudrate = '9600' [9600]
serial_is_host = '<not set>' [<none set>]
bootdelay = '5' [5]
bootretry = '<not set>' [<none set>]
diags_mode = 'Normal' [<none set>]
preferred = '0' [<none set>]
preserve_conf = 'yes' [<dynamic>]
check_physical_presence = '<not set>' [<none set>]

Preboot>
Preboot> diag normal
<DIAGS> sparc_s1-2 Service Processor POST - Start
<DIAGS> U-Boot 2010.03
<DIAGS> Custom Pilot3 U-Boot 0.1 (Sep 16 2016 - 14:48:00) r112301
<DIAGS> Date: 2017-03-23 (Thursday) Time: 7:40:00

<DIAGS> Memory Data Bus Test ... PASSED
<DIAGS> Uboot Mem Test ... PASSED
<DIAGS> Memory Address Bus Test ... PASSED
<DIAGS> Flash Test ... PASSED
<DIAGS> Testing Watchdog ... PASSED
I2C Probe Test - SP
Bus Device Address Result
=== ============================ ======= ======

<DIAGS> PHY #0 R/W Test ... PASSED
<DIAGS> PHY #0 Link Status ... PASSED
Setting 100 BASE-X
Setting full duplex mode.
Mac Addr is 0 10 e0 bb cf fb
<DIAGS> ETHERNET PHY #0, Internal Loopback Test ... PASSED
<DIAGS> Testing RTC . PASSED
<DIAGS> VOLTAGE SENSOR Test ... PASSED
Writing sppost console log to flash
Un-Protected 4 sectors
Erasing
.... done
Erased 4 sectors
Writing
done
Protected 4 sectors
Preboot>

Preboot> boot

Trying bootcmd: bootpkg ...
Reduced ILOM max. image size to 0x740000 to fit in flash.
Date ='Fri Sep 16 16:11:06 PDT 2016', Build ='r112301'
Bad root CRC=ae747100 for data =[ *00340000, len=f97000, sum=6a1ae468 ] in pkg *00140000
Bad vbscdir CRC=860e7944 for data =[ *01770000, len=4d000, sum=94a4d77c ] in pkg *00140000
uboot @0c0000 OK, kernel @142000 OK, root @340000 Bad,
vbscdir @1770000 Bad
Primary image is invalid
Secondary image is invalid
Un-Protect Flash Bank # 1
Un-Protect Flash Bank # 3
Trying primary image...
Trying to boot package at ffffffff
No valid package header at ffffffff (package structure problem)
nothing happens
Preboot> 



关键词:ilom sparc exadata 

相关文章

Exadata exafusion参数在不同版本的变化
19c新特性之实时统计信息收集
Oracle Exadata x8m-2的更新
Oracle Exadata十年
Oracle Exadata x8-2的更新
终于等到你,Oracle 19c真的来了
useful mos note for exadata
Exadata最权威最完整的学习资料
Exadata上收集Cell节点的日志
Exadata上如何重置Cell节点root密码当你忘记时
Oracle性能加速之Write-Back Flash Cache
Exadata and ASM
Top